Maxx Ice MIM50 Manuel d'utilisation et d'entretien télécharger pdf (Page 8)

ICE MAKER INSTALLATION

Unpacking

Remove packaging materials

NOTE: Do not remove any permanent instruction labels or the data label on your ice maker.

Remove tape and glue from your ice maker before using.

 To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or

glue residue can also be easily removed by rubbing a small amount of liquid dish soap

over the adhesive with your fingers. Wipe with warm water and dry.

 Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners

to remove tape or glue. These products can damage the surface of your ice maker.

Cleaning before use

After you remove all of the packaging materials, clean the inside of your ice maker before

Water supply hose

Excessive Weight Hazard

Use two or more people to move and install ice maker.

Failure to do so can result in back or other injury.

Ice scoop

Power cord

Water inlet

Drain outlet

Drain hose

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

Pas de commentaire

Maxx Ice MIM50 Manuel d'utilisation et d'entretien Page 8