Maxx Ice MIM50 Manuel d'utilisation et d'entretien télécharger pdf (Page 12)

Tools needed: flathead screwdriver, Phillips screwdriver

NOTE: Before you begin, unplug the ice maker or disconnect power.

To remove door from hinges:

1. Remove the top hinge cover.

2. Using a Phillips screwdriver, remove the screws, remove the top hinge mat and top

hinge. Keep the parts together and set them aside.

3. Lift the door off of the bottom hinge and set the door aside.

To replace door on hinges:

1. Using a flathead screwdriver, remove the plug buttons from the screw holes opposite the

door hinges, top and bottom. Set aside.

2. Remove the front louver. Set aside.

3. Remove the bottom hinge and place it on the opposite side at the bottom of the door.

4. Position the door on the bottom hinge.

5. Align the door on the bottom hinge and replace the top hinge and top hinge mat.

6. Replace top hinge cover.

7. Push the plug buttons into the original screw holes.

See Figure below:

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 26 27

Pas de commentaire

Maxx Ice MIM50 Manuel d'utilisation et d'entretien Page 12