MIM50 INSTRUCTION MANUAL
8 It is strongly recommended that a water filter be used. A filter, if it is of the proper type, can remove taste and odors as well as pa
9 A standard electrical supply, properly grounded in accordance with the National Electrical Code and local codes and ordinances, is required. The ic
10 Tools needed: flathead screwdriver, Phillips screwdriver NOTE: Before you begin, unplug the ice maker or disconnect power. To remove door from h
11 Water Supply The water supply should be ready at the point of installation. The water supply pressure should be a minimum of 15 psig with a stat
12 into the drain line. NOTE: Never allow the drain hose to hang or loop higher than the floor of the ice storage bin. 3. Screw off the water drai
13 every connection (including connection at the water inlet). 4. If the electrical outlet for the ice maker is behind the cabinet, plug in the ice
14 2. After 3 minutes, the machine will automatically go to the ice-making stage, and the sound of water flowing will be heard. 3. When the batch o
15 enters into the water trough continuously as the water in trough freezes continuously in the evaporator. How to adjust the capacit
16 stored on top of the ice maker can also make noises. The high efficiency compressor may make a pulsating or high-pitched sound. Water runn
17 CLEANING AND MAINTENANCE Periodic cleaning and proper maintenance will ensure efficiency, top performance, and long life. The m
TABLE OF CONTENTS Page ICE MAKER SAFETY ... 2
18 hard, stubborn stains. Also, hard water stains left to sit can weaken the steel's corrosion resistance and lead to rust. Use a nonabrasive cl
19 2. Make sure all ice is off evaporator. If ice is being made, initiate harvest or wait for cycle completion, then turn machine off at the power sw
20 12. Repeat step 5-6 above with clean water to rinse the ice-making system thoroughly. Drain the water as indicated in Step 11. This
21 6. Plug in the ice maker or reconnect power. Water distribution tube cleaning When you find the ice cubes are incompletely formed or t
22 Description of LEDs and buttons: 1. Bin Full (Red) LED: Bin full indicator light When this is lit, the ice storage bin is full of ice or there i
23 TROUBLESHOOTING Before Calling for Service If the unit appears to be malfunctioning, read through the OPERATION section of this manual first.
24 Cubes are partially formed or are white on the bottom. Not enough water in the water trough. Check if the water supply pressure is below 15 ps
MAXXICE3355 Enterprise Avenue, Suite 160 Weston, Florida 33331Tel: 954-202-7419 - Fax: 954-202-7337
1 ICE MAKER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on yo
2 IMPORTANT SAFEGUARDS Before the ice maker is used, it must be properly positioned and installed as described in this manual, read the manual
3 It is important for the ice maker to be leveled in order to work properly. Otherwise water may not flow properly through the evaporator (ice mol
4 Extension Cord Because of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with
5 INTRODUCTION TheMaxx Ice MIM50 Ice Maker produces hard, crystal-clear, gourmet cube ice, and offers convenience for homeowners and hotel guests. An
6 ICE MAKER INSTALLATION Unpacking Remove packaging materials NOTE: Do not remove any permanent instruction labels or th
7 using it. See the "Interior cleaning" in the Cleaning and Maintenance section. Location requirements INSTALLATION CLEARANCES:
Commentaires sur ces manuels